Replacing Rear Drum Brakes

Complete Step by Step Instructions for replacing rear drum style brakes

If you follow these steps you are assured that your brakes will NOT squeal. If you just do a "pad slap" you can count on brake noise. There are plenty of fly by night or mom and pop garages around that publicize they can do you a complete brake job for cheap. Well, sometimes you get what you pay for. If they just swap out the parts without following each step, then you will end up with noisy brakes and who wants that. If you follow the link above you will see just how much is involved and what actually goes into an actual complete brake job.

When you hit the power door lock all four doors lock

QUESTION:
1994 honda accord ex 4door. When you hit the power door lock all four doors lock, however when you shut the door the drivers side lock pops up forcing you to lock the door with a key. I know about the bypass of pulling on the inside door handle and pushing down of the lock but is there any way of making all four doors lock and stay locked? Any way of getting a remote?

ANSWER:
Yes drivers door lock actuator is bad bad needs to be replaced

HONDA Accord V6 3.0 2000- Low Compression

HONDA Accord V6 3.0 2000 (Mileage 120,000)This problem happened slowly over 4 months. It was heating up once in a while, so i used to fill up radiator with water and it was OK. But since last week, I Filled radiator with water fully. Then drove, after 2-3 miles it heats up fully. there is noise in engine. After stopping doesn't start until cool. mechanic said compression in two cylinders is 120psi. engine is damaged, possible head gasket or head is cracked. possible short block is damaged also. He put water in the radiator left open without cap, it shot up while idling engine. Mechanic says the engine is damaged. replace engine. Charging $1900 to replace low mileage engine from junkyard. Mechanic is reputed in town. is this a reasonable cost or should I keep hunting. I want to fix this car instead of buying another one.

Answer:

Yes needs motor about 500 for motor from junkyard so about 1500 is fair

My car will start but will not move out of reverse

Question:
1997 corvette c5 8 cylinder; I just replaced the battery in my car. My car will start but will not move out of reverse which is the gear it was in when it stalled. It was found that the battery was dead so I replaced it. Is there a code reset that needs to be done?

Answer;
Your vehicle should not be able to start in reverse gear. If it does, then your position switch (neutral safety switch) is malfunctioning and should be replaced.

If you mean the shifter moves just fine but the vehicle it self is stuck in reverse no matter where you put the shifter, then either the shifter cable has become disconnected or your trans is broken internally. Put the vehicle on a rack and have someone move the shifter and see if the manual gear selector on the side of the transmission is moving. not.. replace shifter cable. If it does move, rebuild transmission, if you try to put it in gear it won't go to any gear. It will just start to roll if you release the emergency brake , then either the shifter cable has become disconnected or your trans is broken internally. Put the vehicle on a rack and have someone move the shifter and see if the manual gear selector on the side of the transmission is moving. not.. replace shifter cable. If it does move, rebuild transmission.

it ran hot on me last night and also made a few noises

Question:
I have a 99 cougar 6cyl and it ran hot on me last night and also made a few noises and went dead on me,i crank it back up and got it home and popped the hood there were smoke coming from the coolant jug.what could be some diagnostics for this problem?

Answer:
You need to check the coolant level once the vehicle has cooled off. Here are the main reasons a vehicle will overheat.1. Faulty thermostat - Thermostat is usually located before the radiator inside the upper radiator hose. When the temperature of the vehicle gets to "operating temperature" the thermostat will open, allowing coolant to flow through the radiator, where it's cooled.2. Faulty water pump - The water pump helps build up the pressure to make sure the coolant will is flowing. Coolant can become restricted.` 3. Restriction in Radiator will comprimise coolant flow4. radiator fans keep the radiator cool when the vehicle is not moving. If they do not activate at idle, the vehicle can overheat.

Engine Overheating Diagnostics

I have a 99chevy blazer that runs for about ten minutes then stops running

Question:

I have a 90 chevy blazer that runs for about ten minutes then stops running it has trouble starting unless I let it sit for an hour or so.

ANSWER:

The most common reason for this to occur would be due to an ignition module failure. Replace it and the issue should be gone.

Is ok to reuse Gasket which was just install ?

QUESTION:
I have a 1963 Pontiac lemans 185. I just finish rebuilding motor small four cylinder. After putting the engine together I thought I made a mistake. Which caused me remove again the head, intake manifold, and valley pan. I was very upset that I push back to disassy as I worked so hard to product good product. I used copper top on both gaskets, head and intake. The push to disassy was bad choice as discover that my head gasket was install correctly. My question is ok that I reused the gaskets as they were never ran on engine. The intake gasket did take few

ANSWER:
Once head gaskets are torqued down they should not be reused even if the engine has not been run. Once the gaskets compress from torquing, trying to reuse them will ususlly result in a leak. The same rule would apply for the intake manifold.
Don't get me wrong here, some have done it and had sucess but many gaskets have failed when reused. I would not suggest reusing them.